Home Garage Car Wash Station: Drainage, Water and Permit Guidelines | Friday Design Build

Home » Guides » Garages & Shops

Garages & Shops · Friday Field Guide

Home Garage Car Wash Station: Drainage, Water and Permit Guidelines

Where the wash water goes decides whether a home wash bay is legal. Guidelines for drains, sewer and septic, water supply, and finishes in Oregon.

3 min read · Reviewed November 2026 · Friday Design Build

A wash bay is one of the most requested features in an enthusiast's garage, and the one most likely to be built wrong. The equipment is the easy part. The question that decides everything is where the water goes.

Rule one: never to a storm drain

Storm drains carry water straight to streams and rivers with no treatment. Wash water carries soap, brake dust, heavy metals, oil, and grease. Local codes treat that as a violation: the City of Gresham, for example, says so directly. Every other decision follows from keeping it out.

Option 1: An outdoor pad that drains to landscape

The simplest setup. Water runs off a wash pad onto grass or a planted area, where the soil filters it. Gresham's guidance recommends exactly this for ordinary home car washing.

  • Use a small amount of phosphate-free, biodegradable soap.
  • Keep the pad sloped away from the driveway, the street, and any storm inlet.
  • This is for exterior washing only. It is not the place for engine degreasers or wheel acids.

Option 2: An indoor bay that drains to the sanitary sewer

For a true wash bay inside the garage, the drain has to go to the sanitary sewer, not the storm system.

  • Ask the sewer provider first. They decide whether the connection is allowed and what pretreatment is required.
  • Expect a sediment trap or interceptor. Grit and oil have to be caught before the water reaches the sewer. The plumbing inspector and the sewer provider set the requirement.
  • Keep rain out of it. A sewer-connected wash area generally has to be roofed or indoors so stormwater does not flow into the sanitary system.
  • Get a plumbing permit. The drain, the trap, and the connection are all inspected.

Option 3: On a septic system

Do not assume the wash bay can drain to your septic tank. Septic systems are designed for household wastewater, and grit, detergent, and oil are hard on them. Talk to the county onsite wastewater program before you design the bay. If the answer is no, an outdoor pad draining to landscape or a water-reclaim system are the alternatives.

Whatever the option, keep oil changes and engine degreasing out of the wash bay. Oregon DEQ's guidance for commercial washing operations says the same thing: oil changes should not be done in a wash area.

Designing the bay

  • Floor slope. The slab should fall toward a trench drain so water does not run under the door or toward the rest of the garage. This has to be formed before the concrete is poured.
  • Wall and floor finishes. Waterproof wall panels or tile to at least splash height, and a floor coating with grip when wet.
  • Water supply. Hot and cold hose connections with the backflow protection the plumbing code requires. Decide early whether you want a water softener or a spot-free rinse system.
  • Power. A dedicated circuit for a pressure washer, with outlets placed and protected for a wet location.
  • Lighting. Bright, even light on both sides of the car, in fixtures rated for damp locations.
  • Ventilation and heat. A wet bay in an Oregon winter needs air movement and some heat, or it will never dry out.

What to settle before design

  1. Is the property on sewer or septic?
  2. If sewer, what does the provider require?
  3. Will the bay be indoors, covered, or open?
  4. What will you use it for: rinsing, full details, or washing a trailer or RV?

Bring those answers to the first meeting and the wash bay can be designed into the slab from the start. See our car enthusiast garages page for the rest of the build-out.

Common questions

Can wash water go down a storm drain?

No. Storm drains lead to streams and rivers without treatment, and the City of Gresham, for example, treats soapy or dirty wash water entering its storm system as a code violation.

Can a wash bay drain to my septic system?

Do not assume so. A septic system is designed for household wastewater. Ask the county onsite wastewater program before you design a wash bay on a septic property.

Do I need a permit for a garage floor drain?

Yes. A floor drain is plumbing and needs a plumbing permit, and where it discharges has to be approved. Tell your builder about the wash bay before the slab is designed, because the drain and the floor slope are cast into the concrete.

Sources

Reviewed November 2026. Rules change, and zoning, overlays, utilities, and site conditions decide what can be built on a specific lot. Confirm with your planning and building departments before you rely on this guide.

Keep reading

Related guides

All guides →

Before you build

Start with the actual property.

Send us the address, what you want to build, and anything you already know about the site. We'll tell you what applies and what the next step is.

Or email erich@fridaydesignbuild.com